Table of Contents
For a project as big as this, calling a garage door installation in Philadelphia is recommended.
Yet, if you have the expertise and experience, you can also do it on your own.
For your guide, here are some steps on installing a new garage door in Philadelphia:
Step 1: Releasing the garage door’s tension.
The very first thing to do is to release the tension of the garage door.
It will require extreme caution, as the springs of the garage door are under a huge amount of weight as well as tension.
If you handle it improperly, it may cause injuries as well as damages.
Therefore,, before you work on the installation, you should release the tension first from the torsion springs.
Step 2: Disabling the garage door opener.
Before installing a new garage door in Philadephia, it is necessary that you unplug the opener after you have secured the release of the tension from the springs.
For you to safely unplug it, all you need to do is pull the red emergency cord.
This step will then move the arm of the trolley vertically so that you can raise or lower the door using your bare hands.
After this has been done, you can now begin the removal of the sectional door panels.
Step 3: Installation of the panels.
After you are done making sure that the above-mentioned steps have been completed, you can now start the installation of the new garage door.
If you are replacing a garage door with two cars, then you should place a reinforcing bar at the top panel so as to prevent any bowing that is in the center.
Afterward, you can drill the pilot holes if it has not been drilled by the manufacturer itself.
Then, simply utilize the screws in order to have the bar secured to the panel.
Step 4: Tightening the hinges; installing the tracks.
For the next step, secure the top of each of the hinges on top of the top panel.
Place the wheel axles on the hinges from both sides.
Once that is done, you can then install the top as well as the bottom axle supports.
After, have the track installed and make sure that the wheels all lie rightfully in the track so as to make sure that it has proper functionality.
Finally, attach the cable of the door to the hook that is found on the panel axle support that you can locate at the bottom.
Simply place the bottom bracket against the wall.
Step 5: Installing the spring.
For this step, you should assemble the pieces that will support the spring and affix it to the track.
After that, use the ceiling from the support of the previous door.
Consequently, rest the section of the track that is curved on the vertical piece that has been made earlier.
Finally, fasten the other rear to the bracket at the ceiling.
Step 6: Fastening the tracks.
This step will require you to align the horizontal and vertical tracks.
You need to affix these tracks to the door and bolt them together.
Step 7: Attaching the springs.
In installing a new garage door in Philadelphia, the next step is to link the spring anchors to the springs and affix a locking cone on them.
After that, you need to fasten them securely to the header bracket.
Step 8: Attaching the torsion rod and pulleys.
In order to install the torsion rod, simply slide it onto the holes that can be found on the side of the header brackets.
Afterward, just attach the pulleys to both ends of the rod.
Once that is done, attach the cable and then tighten the springs as well.
Keep in mind that you need to employ a garage door installation in Philadelphia to make sure that it is done safely.
ASAP Garage Doors Philadelphia
Installing a new garage door in Philadelphia?
We got you!
ASAP Garage Doors Philadelphia offers various garage door repair services.
As a proven and trusted company, we specialize in garage door repair in Philadelphia as well as garage door installation in Philadelphia.
We guarantee quality services, along with the best professionals in town.
In installing a new garage door in Philadelphia, simply reach out to ASAP Garage Doors Philadelphia.
Do not hesitate to contact us.
Call us now!
