How To Improve Garage Door Opener Reception

Home » Blog » How To Improve Garage Door Opener Reception

Table of Contents

Improving the reception of the garage door opener has been a dilemma for many homeowners.

Openers oftentimes fail to respond to the remote, which decreases its efficiency.

Wouldn’t it be convenient to have the garage door open as soon as you waltz into the driveway?

Well, for some garage door openers, that is not always the case.

Garage doors, due to their straightforward nature, are complicated machines.

While they may appear otherwise, but behind closed doors, and quite literally, are hordes of other devices that make their movements possible.

With that in mind, when one of these devices stops working, the entirety of the garage door also ceases to operate.

If so, the best course of action would be a thorough perusal of one’s garage door.

As such, this article seeks to provide steps and solutions on how to improve garage door opener reception.

Bear in mind, however, that it is best to leave it to the garage door repair in Philadelphia.

Increasing the remote’s distance.

Garage door openers are typically equipped with a range that depends on some of the factors that are each unique to every residence or building.

Hence, the remotes are often created to provide a signal that can be received by the opener’s receiver at a distance of four to five vehicles away from the garage.

This is due to the fact that you can open the remote immediately after pulling into the driveway.

Such is part of the safety feature equipped in a garage to prevent the operation of the garage door when the owner is miles away just to be safe.

Installing an Antenna Extension

First, prepare the following materials or tools:

Stepladder
Screwdriver
antenna extension kit
some insulated wire staples,
light hammer
AA or triple-A battery.

Using a step ladder.

Set a step ladder on the spot near the garage door opener.

Then, depress the tabs that are located on the bottom of the cover behind the unit.

Then, have the cover removed to expose the connection of the antenna.

Loosening the screw and affixing the wire.

Have the screw loosened, which is used to attach the small antenna of the unit and then remove the wire.

Affix the wire at the other rear of the extension of the antenna to the screw and then fasten it.

Sliding the wire.

You have to reposition the ladder, if needed, in order to place the wire of the antenna along to the top of the door or the bottom of the joist that has been opened toward the front of the garage door.

Then, tighten the wire of the antenna every twelve inches with some wire staples as well as a hammer.

Attaching the long stem.

Affix the long stem from the bracket of the antenna that is located at the ceiling or the bottom of the joist using the screws.

After, have the wire of the antenna screwed into the other side of the connection coupler on the bracket.

Then, screw the base of the antenna into the other opposite of the coupler.

Remote control.

Finally, the last step on how to improve garage door opener reception is to have the back of the remote removed.

It depends on the style, but you usually only need to slide the back off or remove the screw.

Then, place the new battery, such as an AA or triple-A in the remote then place the back.

Just a tip, however, have the remote attached to the sun visor in the car instead of using a metal ashtray or a dashboard.

These can potentially disrupt the signal.

Before you install the extension kit, just move the metallic objects that may have signal disrupted that are between the remote as well as the opener.

Afterward, simply test it.