Table of Contents
The garage door runs on tracks whenever it lowers up or lifts down.
These tracks ensure the proper alignment as well as the smooth operation of garage doors.
However, they can be out of adjustment every once in a while due to many causes, each of which can either be natural or unnatural, especially if the tracks have already been worn out or old.
On the other hand, garage door track adjustment is possible with the right garage door repair in Philadelphia.
There are also steps we can take on our own, but just to be sure, it is best to hand it over to the professionals.
To serve as a guide, here are some steps for a garage door track adjustment:
Safety First!
Trying to adjust the track of the garage door will require you to close the door first.
To do this, just loosen one track at a time.
Bear in mind not to remove the entire lag bolts.
Do loosen the bolts that are fastening the track to the jamb.
After that, slide the bracket up until it has reached the right distance.
More than one of the clips will have to be loosened, and then get the track placed in the right location after you have secured the clips.
Take care to remember that the lag bolts are secured as it attaches the clips to the framing.
Garage Door Track Adjustment Proper
Here is where you formally start the job of a garage door track adjustment.
Bear in mind that the overhead area of the garage door track only contains one point for adjustment.
Therefore, the track should have the same distance that is away from the door similar to the wall track.
You should not try to adjust the track while the door is still open.
There are brackets that are holding the track up, which have slots and other holes in them.
The rear of the track will also have to be moved in order for it to be adjusted.
Simply have the bolts loosened or removed if a new hole will need to be used.
Just move the rear of the track closer or far away from the door as much as it is needed.
However, do not have it moved far.
When the track is too far from the door, the garage door itself could fall.
Moreover, a closer track can also cause the door to bind. Have the rear of the track moved and then test the door.
The track should be in parallel with the garage door.
Tighten the bolts and then test the operation of the door.
For your safety,, do not stand below the door and then inspect it for any binding or loosening of the door.
A garage door track adjustment for the overhead area is the same as adjusting the tracks on the side of the door.
The only difference is that you only have one place to adjust the track at.
If the overhead garage door track has not been bent, then these steps should work for you.
The rear ends of the tracks of the garage door are held in position by the metal angles that are attached to the rafters or the ceiling.
These angles have holes, with some being slotted and some being not.
The thing is, you have to place the track in parallel to the door in its open position.
Garage Door Weatherstripping Adjustment
If you notice that there is something wrong with the weatherstripping, you should also pay attention to it.
You can see that there are significant bolt holts that are slotted in order for the track to be connected to the clip.
This, except for the top clip.
Whenever the door closes, it must also touch the weatherstripping.
ASAP Garage Doors Philadelphia
In need of a garage door track adjustment?
We got you!
ASAP Garage Doors Philadelphia offers various garage door repair services.
As a proven and trusted company, we specialize in garage door repair in Philadelphia as well as garage door installation in Philadelphia.
We guarantee quality services, along with the best professionals in town.
For a garage door track adjustment, simply reach out to ASAP Garage Doors Philadelphia.
Do not hesitate to contact us.
Call us now!
